Reinforcement Types in SCIA Engineer
When designing reinforced concrete members in SCIA Engineer, you will come across several different types of reinforcement. Are you not familiar with them all? Here is an overview, with a simple example of a reinforced concrete beam, to help you navigate easier through the design process.
We have described the individual types of reinforcement below. They are structured in a way that follows a common workflow used for the design of reinforcement in concrete members.
Required reinforcement (As,req) is determined by the program in the “Reinforcement design” command. It is the sum of the statically required reinforcement (the longitudinal reinforcement determined for the effect of a combination of N+My+Mz+Vy+Vz and the longitudinal reinforcement designed for the effect of a tensile force due to shear and torsion) and the reinforcement designed as per detailing provisions.
Provided Reinforcement: Basic and Additional
Provided reinforcement (As,prov) is used during the reinforcement design process. The provided reinforcement is created by the program based on your input made in “Design defaults” or in “1D member data.” The detailed settings for the provided reinforcement are defined via the “Library of Provided reinforcement.”
- Provided basic As,bas is the basic reinforcement that is constant along the whole length of the beam – typically the corner rebars.
Provided additional As,add,prov is the additional reinforcement that is used only in those parts of the beam where the basic reinforcement is not sufficient. This means that the additional reinforcement is not constant along the whole length of the beam.
The number of bars of the provided additional reinforcement can be specified in two ways:
The first option allows you to define strictly the number of bars of the provided additional reinforcement (e.g. n = 2). (Please note that if the program calculates that any provided additional reinforcement is needed, it always inputs the number of bars you defined, regardless whether the amount is sufficient or economical.)
The second option enables you to specify a set of options, i.e. a list of possible numbers of bars (e.g. n =0, 2, 3), that can be used for the provided additional reinforcement. In this case, if the provided additional reinforcement is needed, the program evaluates individual options from the list (possible number of bars mentioned above) and uses the first number of bars that satisfies the condition of the required amount of provided additional reinforcement.
Additional reinforcement As,add,req is determined by the software if the provided reinforcement (based on its current settings) does not sufficiently cover the required reinforcement. It is calculated as the difference between the required reinforcement and the provided reinforcement. In other words, it is the reinforcement that must be added to the provided reinforcement to meet the needed amount of the required reinforcement.
All the above-mentioned types of reinforcement are considered in the reinforcement design; however, none of them is taken into account in the reinforcement checks of concrete members. To perform the reinforcement check, you must specify the practical reinforcement.
Practical reinforcement As,pract enables you to perform the reinforcement check. You can define it using commands from the “Reinforcement input + edit” service.
To learn more about the practical reinforcement, please refer to the chapter “REDES - input of practical reinforcement” in SCIA Engineer Help.